avaya 9620 ip telephone end user guide

# This value must match the extension length set on your # call server.
# SET lang1file "mlf_S31_v51_russian.Traditionally, the only way to receive new telephone capabilities - was to purchase a completely new phone. .Txt" # # Third Language File Name # Contains the name of the third language file.# # setting value # 0 16dB (default sidetone level) # 1 18dB #.5dB # 3 21dB #.8dB (lowest value, inaudible) # 5 13dB (loud) # # SET audiosths 0 # # WML browser settings # # # The wmlsmall setting.Investment Protection - Modules and Adapters.# The webhome and webcoding parameters are set up # to point your 4630 IP telephones to this hosted site.# The default is 240 minutes.# Unnamed registration provides the telephone with # TTI-level service, enabling a user, for example, to # dial emergency services such as 911.# SET rtcpmon # # rtcpmonport sets the port used to send rtcp information # to the IP address specified in the rtcpmon parameter.# A value of 1 or 3 makes the headset ignore a disconnect # message.# # English Language Selection Status # Specifies whether built-in English language text strings # are selectable by the user.The user cannot change any setting.# 1 for auto-negotiate # 2 for 10Mbps half-duplex # 3 for 10Mbps full-duplex # 4 for 100Mbps half-duplex # 5 for 100Mbps full-duplex # 6 for 1Gbps full-duplex (96xx phones only) SET PHY1stat 1 # # PC Interface Status # Controls the speed and.Go to Options on your 4630 to complete setup of # this feature.Wml # SET wmlidleuri m/elmodocs2/avay.
# Accesses to these addresses will not go through the # proxy server.
# # SET headsys 1 # # Audio Environment Index # Enables you to customize the telephone's audio # performance.




# A value of 0 disables Backup/Restore.This has been found to reduce employee stress and fatigue.The leftmost bit controls the Audio # push mode.The default.# # A value of 1 enables AGC.# SET DOT1X 0 # # # icmp settings # # # Destination Unreachable Message hp deskjet 1280 instruction manual Control # Controls whether icmp Destination Unreachable messages # are generated.
# SET PHY2vlan 0 # # Audio Priority Value # Sets the layer 2 priority value for audio packets # from the phone.